Fanatec DD2 Wheelbase oscillation & shaking on straights and while driving slow e.g. in pit
Lukas Stute
Member
Hi guys,
first of all i have only had the dd2 wheelbase for a week, so i am quite inexperienced when it comes to the settings.
In ACC I have very strong oscillations in the steering wheel on straight or even when driving slowly (I cannot keep the steering wheel steady or straight).
Does anyone have a tip on how to fix this?
Setup:
Fanatec DD2 Wheelbase
Fanatec Formula V2 Wheel
Fanatec V3 pedals
PC Driver: 356
Wheelbase firmware: 670
Wheelbase Motor Firmware: 38
Steering wheel firmware: 28
Fanalap settings:
SEN: Auto
FF: 50
LIN: Off
NDP: 25
NFR: 0
NIN: 10
INT: 4
FEI: 80
FOR: 100
SPR: 0
DPR: 50
ABS: Off
SHO: 100
BRF: 40
MPS: Const
ACC Settings:
Gain 60
Minimum Force 0
Dynamic Damping 0
Road Effects 0
Frequency 333hz
Thank you for your help! :)
Comments
That's normal in ACC, if it bothers you then increase NDP or NFR
Thanks for your prompt reply. I just updated to PC driver 365. I am currently using your Fanalap setups for ACC, I will increase NDP or NFR there. Can't i use dynamic FFB to avoid oscillations and shaking?