Clubsport V3 - Brake too sensitive how to adjust?
Stu Whisson
Member
Hi,
I'm unable to reset the break sensitivity in Fanatec Wheel Properties. I clicked on max when I hadn't pressed the peddle as far as normal. Double clicking the max doesn't seem to reset it, or simply pressing it again with the break where I would like it, doesn't work either! I've even tried manually changing the setting directly on the break peddle but this is set to max force for the load cell.
Any ideas? As I'm locking up so much in games.
Thanks
Stu
Comments
Do you have manual calibration mode selected?
Check the brake force setting in the wheel menu. Mine defaulted to 50 and that was way too easy, bump to 100 and you'll find it quite stiff. I like it at 90 personally.
Its the other way around? If you lower the value you will need to apply more force, at least thats the case for my V3s.
Open the Fanatec control panel where you can set max / low and fully press the pedal and click "set max"? Also, adjust the brf value. Make sure you enabled manual mode too.
After than set the brf value to 50 and if you want it more firm / stiffer decrease the value.
Higher value = higher force required for maximum brake pressure.
Lower value = lower force required for maximum brake pressure.
It's not complicated.
It is reversed with an older driver
Im using an older driver, 3.28, and if i lower my value i need to apply more force.